Does anybody have any suggestions for loosening and keeping loose the filter housings on a pure water filter system? I have an IPC Hydrocart. I have had days where the housings seemed a little tight and tougher to remove than normal, but today they nearly killed me. I fought with them for 20-25 minutes before finally breaking them loose. This was for the 2 pre-filters and the DI filter housings.
Once I got them off I checked the rubber o-rings and there seemed to be plenty of silicone lubricant on them. When I put them back together I put more silicone on them and tried to tighten them a little less; just a little bit beyond hand-tight. After I turned-on the water I had one that was dripping a bit so I had to snug it up a little more.
I'd appreciate any other suggestions.
Thanks,
Once I got them off I checked the rubber o-rings and there seemed to be plenty of silicone lubricant on them. When I put them back together I put more silicone on them and tried to tighten them a little less; just a little bit beyond hand-tight. After I turned-on the water I had one that was dripping a bit so I had to snug it up a little more.
I'd appreciate any other suggestions.
Thanks,
from Window Cleaning Resource http://ift.tt/1z145Hl
Visit Us: Pine Country Window Cleaning
via IFTTTIFTTT
No comments:
Post a Comment